| Author |
Message |
|
pcsandhya82
|
Post subject: PIC18f4550 USB Device not recognised in winxp  Posted: Thu Dec 29, 2011 7:25 am |
|
Joined: Thu Dec 29, 2011 7:18 am
Posts: 3
|
|
Hi,
I followed your tutorial and successfully built and burned the program for WFF Generic HID Demo 3 onto my pic18f4550. But when I connect it to my PC, it flashes a message "USB Device not recognised- A Device has malfunctioned.." What could be wrong? I have used the circuit that is there in the tutorial, but havent connected the LED and push button switch on port A. I just need my PC recognise this device.
Regards,
Sandhya.
|
|
  |
|
 |
|
Simon Inns
|
Post subject: Re: PIC18f4550 USB Device not recognised in winxp Posted: Thu Dec 29, 2011 2:21 pm |
|
Joined: Thu Apr 01, 2010 6:23 am
Posts: 898
|
|
If you are using unaltered firmware then it is probably a hardware issue; either the circuit isn't correct or you have the D+ and D- wires on the USB reversed. Make sure you verify that you have used the correct capacitors also (taking note of the uF, nF anf pF values).
|
|
| |
|
|
|
pcsandhya82
|
Post subject: Re: PIC18f4550 USB Device not recognised in winxp Posted: Thu Dec 29, 2011 4:14 pm |
|
Joined: Thu Dec 29, 2011 7:18 am
Posts: 3
|
|
Hi,
Let me try rewire the circuit. D+ and D- are not reversed.
Thanks,
Sandhya.
|
|
| |
|
|
|
pcsandhya82
|
Post subject: Re: PIC18f4550 USB Device not recognised in winxp Posted: Tue Jan 03, 2012 8:35 am |
|
Joined: Thu Dec 29, 2011 7:18 am
Posts: 3
|
|
Hi,
It worked. It was a hardware issue. My PCB was being shorted internally.
Thanks for your response.
Regards,
Sandhya.
|
|
| |
|
|
|
