 |
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
grimstoner
|
Post subject: Code does not start on power-up, only when conn to PICKIT2  Posted: Sat Jan 01, 2011 6:42 pm |
|
Joined: Fri Dec 31, 2010 10:21 am
Posts: 7
|
|
Hi
Thanks for your guidance... I've built your case LCD using a 2250 to be a external indicator for my HTPC running XBMC.
One thing I noticed during my project, is that the PIC does not automatically start running the code. I have to hit Debug in MPLAB (with my PICKIT2 connected), and only then is the "PC CASE LCD VERSION 1.0" message displayed. If I disconnect the PICKIT2 and power up my circuit, nothing happens... I used your code exactly, so it couldn't be a config bit that I set incorrectly. I've checked my MCLR pin, it's also correctly connected. Is there anything you can think of that might cause this to happen?
|
|
  |
|
|
|
grimstoner
|
Post subject: Re: Code does not start on power-up, only when conn to PICKI Posted: Sat Jan 01, 2011 6:46 pm |
|
Joined: Fri Dec 31, 2010 10:21 am
Posts: 7
|
|
...
Was building in Debug mode. Changing to Release fixed it.
Thanks anyhoo
|
|
| |
|
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Users browsing this forum: No registered users and 1 guest |
| |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
|
